The most common reason for replaci.
Maytag freezer door handle loose.
The handles are installed by the owner or installer as directed in the installation instructions.
If replacing the freezer door handle remove the screws holding the handle to the freezer door.
If your bottom freezer refrigerator handle is loose making noise or even falls off after use it was not installed properly by the owner or installer.
Once both screws are loose pull the damaged refrigerator handle off of the door to install a new handle.
To do this grip the handle securly and yank the handle straight to the left and it will unclip and pull off.
Check the setscrews per the instructions below.
If the handle is still loose tighten the screws on the handle to fully secure it.
If you need further instruction i am here.
Download a copy of the installation instructions.
Once the handle is pulled off you can tighten the screws going into the handle bracket on the freezer door and you should be good to go again.
Hello my name is the handle is just loose then there are set screws on the back side of the handles that you can tighten.
Test the handle tightness by opening and closing the freezer door a few times.
There is a lot of force needed to unclip the handle.
How do i get to the screws holding it.
Place the new handle on the door for side by side doors the small screws should face the other door and ensure that the top and bottom of the handle is placed over the screws in the door.
It is a maytag ice20 french door bottom freezer.
Ask your own appliance question.
If either the refrigerator or freezer handle is loose or not tight against the door they might not have been installed correctly.
Carefully twist the door handle and gently pull it away from the freezer.
The setscrews might have only been partially tightened when the handles were installed.
Some bottom freezer handles are not factory installed.
This video provides step by step repair instructions for replacing the freezer drawer handle on a frigidaire refrigerator.
Order a new freezer door handle here and install it the same way the old one was removed.